Stadler Form CHARLY Mode D'emploi page 7

is fitted on protection grille rear as shown in illustration on page 2–3.
Close the two grilles by fastening the 8 fixing clips (13) (or 7 in the case
of Charly little). Ensure that all fixing clips (13) are fastened.
F. Secure the two grilles (7 and 11) with securing screw (14).
Setting up / operation
1. Place Charly at the desired position on a flat surface. Connect the mains
cable (17) to a suitable plug socket.
2. Switch on the Charly fan at the controller (15) and set the desired speed
(Positions 1–3, from gentle breeze to powerful circulation).
3. Push the oscillating knob (16) down to switch on the oscillation and pull
the oscillating knob up to switch off the oscillation.
4. The direction of airflow can be set in 4 positions. By carefully moving
the motor housing (4) up and down, the direction can be adjusted (click-
ing noise).
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (17) from the socket.
Attention: Never submerge the appliance in water (danger of short-circuit).
• For external cleaning, rub with a damp cloth and then dry thoroughly.
• To clean the fan blades, remove securing screw (14), undo all fixing clips
(13) and carefully lift off protection grille front (11). Now you can wipe the
fan blades (9) with a damp cloth and dry well afterwards. After cleaning,
replace protection grille front (11) on appliance (fit top positioning clip: 12),
fasten all fixing clips (13) and fasten securing screw (14) tightly.
Repairs
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the warranty
lapses and all liability is refused.
• Never operate the appliance if the adaptor or plug is damaged, after it has
malfunctioned, if it has been dropped or has been damaged in any other
way (cracks/breaks in the casing).
• Do not push any object into the appliance.
• If the appliance is beyond repair, make it unusable immediately by cutting
through the cable and hand it in at the collection point provided for the
purpose.
Disposal
The European directive 2012 / 19 / CE on Waste Electrical and Electronic
Equipment (WEEE), requires that old household electrical appliances must
not be disposed in the normal unsorted municipal waste stream. Old appli-
ances must be collected separately in order to optimize the recovery and
recycling of the materials they contain and reduce the impact on human
health and the environment. The crossed out "wheeled bin" symbol on the
product reminds you of your obligation, that when you dispose of
the appliance it must be separately collected. Consumers should
contact their local authority or retailer for information concerning
the correct disposal of their old appliance.