Troubleshooting; Recycling - Rothenberger Industrial WPS 190 Notice D'utilisation

1500000062_Anleitung_D,GB,F,I

TROUBLESHOOTING

Fault
Device does not cut:
The cutting blade does not
heat up
Blade does not cut cleanly
Cutting wire is hot
permanently

RECYCLING

This symbol indicates that this product may not be disposed of together with domestic
waste in compliance with the (2002/96/EC) Regulation pertaining to waste electrical and
electronic devices (WEEE). This product must be handed in at an designated collection
point. This can occur, for example, by returning it when a similar product is purchased
or by handing it in at an authorised collecting point for the recycling of waste electrical
and electronic equipment. Owing to potentially hazardous substances that are frequently
contained in waste electronic equipment, incorrect handling of waste equipment may
have a negative impact on the environment and on the health of human beings. By
disposing of this product correctly, you are also contributing towards an efficient use
of natural resources. Information on collecting points for waste equipment can be
obtained from your local authority, the public waste disposal authority, an authorised
institution for the disposal of waste electrical and electronic equipment or the waste
collection services.
22.12.2011 15:34 Uhr
Possible cause
No mains power
The cutting blade is
not hot enough
The trigger is faulty
30
Seite 30
Remedy
Connect the machine the
mains.
If necessary have the mains
cable replaced
Increase the temperature using
the temperature control
Disconnect the device from the
mains immediately.
Have the device repaired
by an authorised workshop
before you use it again.