After Finishing Work; Working Instructions - Rothenberger Industrial WPS 190 Notice D'utilisation

1500000062_Anleitung_D,GB,F,I
AFTER USE
- After use place the machine on to the stand supplied. This is the ideal way to store the machine
while cooling.
- Clean the cutting blade after finishing work while it is still warm. Use the brush supplied.
- After finishing work and once the machine has cooled down it should be stored in the plastic
case supplied.

WORKING INSTRUCTIONS

Bear in mind that the cutting blade remains hot for a period of time after the device
is switched off.
CAUTION - DANGER OF BURNS!
PREPARING TO START WORK
Check that the material you wish to cut is non-combustible. Highly flammable or combustible
rigid foam may not be cut with this machine.
Check the information supplied by the manufacturer of the material you wish to cut for
information on toxic contents and for advice on working with the foam.
Ensure that you work in a well-ventilated area.
Make a trial cut on a piece of scrap material before starting your planned job.
22.12.2011 15:34 Uhr
28
Seite 28