Appendix; Troubleshooting; Dimensional Drawing Of The Stage Attatchment - Zeiss WSB ZPiezo CAN Manuel D'utilisation

WSB ZPiezo CAN
6

APPENDIX

6.1

Troubleshooting

Description of the fault
Controller not responding
(no LEDs lighting up)
Controller not responding
(blue and yellow LEDs lit up)
WSB Wheel handwheel not
responding (position
displayed)
6.2

Dimensional drawing of the stage attatchment

Cable length 1.8m
07/2015
APPENDIX
Troubleshooting
Cause of the fault
No power supply
Power supply unit
defective
Electronics defective
Electronics defective
Handwheel is inactive.
is
Display is showing
"off".
432339-9010-000
Remedy for the fault
Establish a power supply (see 3.1).
Switch on the switch on the front of the device
(see 3.2).
Exchange the power supply unit (see 4.2)
Contact ZEISS Service
Contact ZEISS Service
Press the middle button (Fig. 4/2) until the
display shows "on".
Carl ZEISS
17