Changing The Power Supply Unit - Zeiss WSB ZPiezo CAN Manuel D'utilisation

Carl ZEISS
4.2

Changing the power supply unit

Only the table-top power supply unit specified by the manufacturer may be used.
Before opening the device, always withdraw the mains plug from the mains socket.

Withdraw the mains plug for the table-top power supply unit from the mains socket.

Withdraw the R7B power supply unit plug (Fig. 3/10) from the DC voltage socket (Fig. 3/1).
To do this, pull the lock release in the direction of the arrows to release the R7B power
supply unit plug (Fig. 5).
Fig. 5

Connect the table-top power supply unit to the R7B power supply unit plug (Fig. 3/10) at the
DC voltage socket (Fig. 3/1) on the controller.

Plug the mains cable into the power supply socket of the power supply unit (Fig. 3/9).

Insert the mains plug of the table-top power supply unit into the mains supply socket.
14
CARE AND MAINTENANCE
Changing the power supply unit
Power supply cable for the table-top power supply unit
432339-9010-000
WSB ZPiezo CAN
07/2015