Start-Up - Zeiss WSB ZPiezo CAN Manuel D'utilisation

WSB ZPiezo CAN
3.2

Start-up


Using the On/Off switch (Fig. 2/1), switch the controller on.
 The blue "POS" indicator LED lights up whilst the system is being calibrated and is moving to
the start position. When the yellow "Ready" indicator LED lights up, the system is ready.

The display shows the standard start position (250.00 µm).
 When the stage attatchment is moving to a new position the blue "POS" indicator LED (Fig.
2/2) lights up.
 When the target position of the stage attatchment has been reached, the yellow "Ready"
indicator LED (Fig. 2/3) lights up.
 When communication with the respective axis is established, the green "Channel" indicator
LED (Fig. 2/4) lights up.

After the usage session is finished, switch the controller off at On/Off switch (Fig. 2/1). If the
WSB ZPiezo CAN is not going to be used for some time, withdraw the mains plug of the
table-top power supply unit from the socket, so as to disconnect it from the mains supply.
07/2015
OPERATING CONCEPT
Start-up
432339-9010-000
Carl ZEISS
11