Operating Concept; Connecting The Wsb Zpiezo Can Controller - Zeiss WSB ZPiezo CAN Manuel D'utilisation

Carl ZEISS
3

OPERATING CONCEPT

3.1

Connecting the WSB ZPiezo CAN controller


Connect the WSB ZPiezo Wheel handwheel input device to the HID socket (Fig. 3/3) of the
controller

Connect the stage attatchment connection cable to the Z-Stage socket (Fig. 3/2). (see also
Section 5)

Connect the mains cable to the mains connection socket (Fig. 3/9) of the table-top power
supply unit.

Connect the table-top power supply unit to the R7B power supply unit plug (Fig. 3/10) at the
DC voltage socket (Fig. 3/1) on the controller.

An analogue voltage signal (0-10V), can be used to connect the respective system
components to the analogue in socket (Fig. 3/8) on the WSB ZPiezo CAN controller.

The controller can be connected to a PC card or other system components via the trigger
sockets (Fig. 3/4).

The controller can be connected to a computer or other system components via the USB
(Fig. 3/5), RS232 (Fig. 3/6) or CAN port (Fig. 3/7).
Fig. 3 Connections to the WSB ZPiezo CAN controller
1 DC voltage socket
2 Z-Stage socket
3 HID socket
4 Trigger sockets
5 USB socket
10
OPERATING CONCEPT
Connecting the WSB ZPiezo CAN controller
432339-9010-000
6 RS232 socket
7 CAN sockets
8 Analog in socket
9 Mains connection socket
10 R7B power supply unit plug
WSB ZPiezo CAN
07/2015