Sentiotec wave.com4 sound&light Instructions De Montage Et Mode D'emploi page 38

Instructions for installation and use
6. FAULTS, CAUSES, SOLUTIONS
This list schows possible problems, their causes an recommended procedure
for resolving them.
Fault
The display of the colour module can-
not be activated.
Colour lamp does not light although
the colour operating element shows
colour numbers.
The colour of the lamp and the num-
bers on the display change but do not
correspond.
One colour and its mixed colours are
missing.
The colour of the lamp and the numbers
on the display do not change.
The colour of the lamp and the numbers
on the display change automatically.
WORLD OF WELLNESS
Possible cause
Check power supply to the power
element. If this is in order but none
of the symbols on the display lights,
then check the data connection of the
colour operating element.
No lamp supply between LED coloured
lamp and LED power element; Check
cables/terminals; and if need be check
the programming (brightness of the
individual colours).
Check connection sequence of the con-
nection between LED coloured lamp
and LED power element.
Check terminal wire of the connection
between LED coloured lamp und LED
power element and if need be check
the programming (brightness of the
individual colours).
Set to "Automatic" mode; If need be
connect through manually and if need
be check the programming (interval
period of the individual colours)
Set to "Manual" mode; If need be check
programming (interval period of the
individual colours)
p. 18/20