AL-KO Highline Serie Mode D'emploi page 27

without remote throttle control, with primer (
1. Press the primer button 3 times at intervals of about
2 seconds ( 16). If the temperature is below
10 °C, press the primer button 5 times.
2. Pull in the safety brake handle on the handlebar and
hold it ( 17) – the brake handle does not lock.
1. Pull out the starter cord sharply, then allow it to
slowly rewind ( 18).
Motor speed (rpm value) is fi xed.
Motor speed cannot be adjusted.
without remote throttle control, without primer/
choke
2. Pull in the safety brake handle on the handlebar and
hold it ( 17) – the brake handle does not lock.
3. Pull out the starter cord sharply, then allow it to
slowly rewind ( 18).
Motor speed (rpm value) is fi xed.
Motor speed cannot be adjusted.
Electrostart without primer/choke (
1. Set the throttle lever to the "START" position
( 13/1).
2. Pull in the safety brake handle on the handlebar and
hold it ( 16) – the brake handle does not lock.
3. Turn the ignition key fully to the right in the ignition
lock ( 18).
4. As soon as the motor starts running, release the
ignition key (it returns automatically to position "0").
5. According to the desired motor speed, set the
throttle lever to a position between min and
max.
16) Turn the motor off
Lawnmower without blade coupling
1. Set the throttle lever to position min (
2. Release the safety brake handle (
Wheel drive (optional)
Switching on the wheel drive
1. Press the transmission control handle against the
Switching off the wheel drive
1. Release the transmission control handle (
13)
Vario transmission (Vario Speed) (optional)
The Vario transmission allows continuous variation of the
ground speed of the lawnmower.
- The motor is switched off.
Caution - danger of serious cut injuries!
The motor may continue running. After switching
off, make sure the motor has stopped turning.
(
Caution!
Engage the transmission only when the motor is
running.
handlebar and hold it (
control handle does not lock.
- The wheel drive is switched on.
- The wheel drive is switched off.
Caution!
Operate the lever only when the motor is running.
Operating the lever without the motor drive may
damage the drive mechanism.
To increase the speed, pull the lever (
towards ( 20/2)
To lower the speed, pull the lever (
( 20/1)
Always adjust the ground speed to suit the current
ground and lawn conditions.
GB
12/2).
22).
20)
19) – the transmission
21).
20)
20) towards
27