Publicité
Les langues disponibles
Les langues disponibles
Nissan Double Cab. 4x4
2002 - ....
Ref. 1344
Fitting instructions
1)
Disassemble the bumper and remove the spare wheel. Permanently remove the bumper supports.
2)
Slide the mounting lats (k) and (o) into the chassis beams until the points (A), (B) and (C) of those pieces
fit the holes in the chassis beams. Place the mounting pieces (g) against the outside of the chassis beams
and insert the necessary bolts.
3)
Now place the mounting pieces (i) and (j) with points (A) on the already inserted bolts. The points (D) of
(i) and (j) fit in the holes in the chassis beam. Place the mounting pieces (h) against the outside, insert the
necessary bolts, washers and nuts, but do not tighten them.
4)
Place the tow bar between the already mounted pieces (g), so that points (F) and (F') of the tow bar fit
with those of the mounting pieces. Insert the necessary bolts and washers and tighten everything slightly.
5)
Place the supporting beams (m) and (n) with the points (L) on the liberated drillings (where the originals
were attached). Insert the bolts, washers and nuts and tighten them firmly. Now slide the bumper over
the tow bar and insert the bolts, washers and nuts in (E). Attend the position of the bumper in the slot
holes until it is parallel with the car.
Then tighten everything firmly (tow bar + bumper).
6)
Assemble (*) and tighten also firmly.
Composition
1 tow bar reference 1344
1 flange ball 50T
2 bolts M16x50 and M16 nuts
2 security washers M16
1 security shackle
or
1 flange ball 50V
4 bolts M10x50 and M10 nuts
4 security washers M10
8 bolts M12x45
20 security washers M12
10 nuts M12
12 bolts M12x35
6 washers 40x35x12x4
4 bolts M10x30
4 security washers M10
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
4 nuts M10
(*)
6 bolts M8x25
(*)
6 security washers M8
(*)
6 nuts M8
6 washers ø25x8,4x2
(*)
2 mounting pieces (h)
(*)
1 mounting piece (i)
(*)
1 mounting piece (j)
(A)
1 mounting piece (o)
(A-B-C-D-F-F') 1 mounting piece (k)
(A-F')
2 mounting pieces (g)
(B-C-D-F-F')
1 mounting piece (m)
(C-E)
1 mounting piece (n)
(E)
(E)
All bolts and nuts : quality 8.8
(E)
(L)
(L)
(L)
(L)
(D)
(A-D)
(A-D)
(A-B-C)
(A-B-C)
(A-B-E-F-F')
(E-L)
(E-L)
Publicité
