Danby DAC10000 Guide D'utilisation Et Soins De Propriètaire page 9

Installation Instructions
HOW TO
INSTALL (cont)
IF AC IS BLOCKED BY
STORM WINDOW
REMOVING AC FROM
WINDOW
Cut foam seal and insert in the space between the upper and lower
7
sashes. (Fig.13).
Fig. 13
Add wood as shown in Fig.14 or remove storm window before air
conditioner is installed.
Fig. 14
STORM
WINDOW
FRAME
OR OTHER
OBSTRUCTION
If Storm Window Frame must remain, be sure the drain holes or slots are
not caulked or painted shut. Accumulated Rain Water or Condensation
must be allowed to drain out.
• Turn AC off, and disconnect power cord.
• Remove sash seal from between windows, and unscrew safety lock.
• Remove screws installed through frame and frame lock.
• Close (slide) side panels into frame.
• Keeping a firm grip on air conditioner, raise sash and carefully "rock"
air conditioner backward to drain any condensate water in base of unit.
Be careful not to spill any remaining water while lifting unit from window.
Store parts WITH air conditioner.
8
1 1/2" min
(38mm)
SASH
BOARD
THICKNESS
AS REQUIRED,
FOR PROPER
PITCH TO
REAR, ALONG
ENTIRE SILL.
FASTEN WITH
NAILS OR
SCREWS.