Valor Retrofire RA24ZC Guide D'installation page 4

2. Place the tabs at the rear edge of the heat shield
into the slots. Secure the heat shield using 2 screws
on each side. Screw from within the ZC box.
3. Slide the convection and extension baffles supplied,
channels downward, onto the firebox baffle.
Convection Baffl e and Extension
supplied with heater
Convection
baffle—has
one raised edge
Extension baffle has
two raised edges
4. Finish the installation of fuel bed, remote control,
glass, etc. as per instructions packed with the
RF24B heater.
4
Convection
baffle
Slide convection baffle,
Extension
channels downward on
baffle
firebox baffle.
Slide extension baffle
over convection baffle,
channels downward.
Install Trims
Note: Outer trims may require extending
or custom trims may be required to cover
openings.
• The trim packs may contain redundant parts not
required for these applications as trims are common
to other model heaters. Discard unused parts.
• Barrier screens are supplied with most inner front
trims as well as with the RF24 appliance. Only one
barrier screen is required. Use the barrier screen
supplied with the chosen inner front trim.
1. Fasten the mounting brackets supplied with the zero
clearance kit to the back of the outer trim using
screws provided.
Note: It may be necessary to extend the outer trim
to cover the combustible wall opening. Custom
non-combustible sheet metal pieces may be added
to the extruded aluminum trims and fastened using
the screw channel on the back of the trim.
2. Fasten the outer trim with the mounting brackets
attached to the side flanges of the ZC box using 2
screws each side.
Fasten outer trim with
mounting brackets to
ZC box using 4 screws