Venga VG RVC 3002 Mode D'emploi page 15

FLOOR MOPPING
Once the floor has been thoroughly vacuumed, you can swap the dust collector for the
water tank included in the original packaging to continue the cleaning process. The
robot is equipped with a water tank with water flow adjustment: the amount of water
used to moisten the mop can be electronically controlled with the remote control.
•
Open the airtight lid and pour water into the water tank.
Note: Remove the water tank before charging the robot. Do not
use the mop outdoors. Remove carpets before using the mop to
prevent water damage.
•
Attach the mop to the underside of the water tank and
make sure it is properly attached
•
Remove the dust tank and insert the water tank into the
robot.
Note: After cleaning the floor, empty the water tank, rinse it
thoroughly with clean water and store it in a dry place to
avoid unpleasant odours. Make sure the 4 water drainage
holes are not blocked. If necessary, unlock it with a small
needle.
•
It is possible to set different water flow levels for specific cleaning needs. Press the
water flow button
The water flow
is closed.
on the remote to adjust the water flow speed.
The water flow
is small.
15
The water flow The water flow
is medium. is large.
VG RVC 3002