Resetting To The Factory Default Settings - Eneo IED-64M2812MAA Guide D'installation Rapide

EN
Select the „Set IP Address [dhcp / static]" option to open a window for setting the camer-
as IP properties. When you are done click the „OK" button to update the camera settings.
Now you can also perform a factory reset of the camera inside the eneo Site Manager.
For further information, please refer to the eneo Site Manager Quick Start Guide.

Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of Users Manual) or use the
Reset button on the network camera inside the bottom cap.
microSD Card Slot
Reset Button
11