Installation; Installing And Adjusting Camera - Eneo IED-64M2812MAA Guide D'installation Rapide

Installation

Installation
For the operation of the Network Camera, it is necessary to connect a network cable for
data transmission, power connection from supplied power adapter. Depending on opera-
tion methods, it is possible to connect an alarm cable additionally.
The dome camera should be attached to a structural object, such as hard wood, wall stud
or ceiling rafter that supports the weight of the dome camera. For its fixation on different
locations, please consult with an installer.

Installing and Adjusting Camera

1. Loosen the 4 torx screws located on the front of the housing leaving the screws
intact in the front portion.
Torx lock screw (x4)
2. Using the template sheet make mounting holes and cable hole in the place (ceil-
ing or wall) to which the camera is to be installed.
3. Fix the bottom case to the mounting place using supplied Anchors (4x) and
Mounting Screws (4x).
6
Top case
Bottom case & camera