Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BEFORE USE
Check the work area to make sure that it is clear of debris and clutter.
Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.
OPERATION
1. Mounting and dismounting of the bit
Loosen
Sleeve
FREE (release)
Fig. 5
LOCK
Sleeve
Tighten
Fig. 6
2. Confirm that the battery is mounted correctly.
(1) Mounting the bit
Slide the sleeve to the FREE (release) side.
Rotate the sleeve to the left (counterclockwise as seen
from the front) to open the clip on the keyless chuck. (See
Fig. 5)
Insert the bit, for instance an item such as a screwdriver
into the keyless chuck and after tightening the sleeve to
the right (as viewed from front), slide the sleeve to the
LOCK side. (See Fig. 6)
CAUTION:
Always slide the sleeve to the LOCK side before attempt-
ing to use the drill.
(2) Dismounting the bit
Slide the sleeve to the FREE (release) side.
Rotate the sleeve to the left to loosen, and then take out the
bit. (See Fig. 5)
CAUTION:
Never use excessive turning force while the sleeve is set
at the LOCK side. Doing so may damage the keyless
chuck.
NOTE:
Loosening stuck or hard to move sleeves.
Grasp the bit installed in the keyless chuck, in a vise or
similar tool.
Slide the sleeve to the FREE (release) side.
Set the cap position to "3-13" and turn on the switch. The
motor then starts.
Finally, rotate the sleeve to the left, and it will loosen.
English
15
Publicité
Table des Matières
