Amann Girrbach Artex Transfer Jig Mode D'emploi page 5

USER MANUAl
ARtEx tRANSfER JIG
®
PRoDUCt DESCRIPtIoN
Another direct alternative to the transfer stand
and to the direct facebow transfer. The universal
joint with bite fork is attached to the jig holding
the registration in axis relation while fixed at the
bottom part of the Artex
oPERAtIoN/HANDlING
Remove anterior guidance pin and holder. Insert
anterior guidance table in top part. Insert transfer
jig in bottom part up to stop and secure. The
surface of the incisal table lies on the transfer jig.
Insert bite fork support in bottom part (via
magnet or screwed). Insert 3-D universal joint in
the socket on the transfer jig and fix in position
with the adapter screw. (fig. 1 - 3)
Turn articulator upside down. Move cross bar of
the bite fork support until it contacts the bite fork
and tighten up the knurled screw. The cross-bar
can be brought closer by means of the screwed
thread and/or telescopic fitting. (fig. 4)
Place articulator in working position. Insert
maxillary model in the bite tork impressions. Insert
base plate in top part. Check space available
between model and top part and regulate if
necessary, e.g. by trimming the model or applying
piaster in two stages. (fig. 5 + 6)
Mix an appropriate quantity ot mounting plaster
tor the space avaiIable to a creamy consistency.
Moisten the base of the model. Apply mounting
plaster to the base plate and the moistened
surface of the model. Close top part. Release
plaster resistance (relieve stress) by knocking on
top part. (fig. 7 + 8)
articulator.
®
Individual parts:
Order No.:
218631 Artex Transfer Jig
GB
5