Troubleshooting; Technical Data - Caffitaly System Flexicup M29H Mode D'emploi

PROBLEM
No coffee comes out.
Indicator light E blinks
RED.
The coffee is not hot
enough.
The lever cannot be
lowered.
Indicator light E is lit up
steady RED.
When a button is
pressed to dispense
coffee, the machine
seems to start but
then stops without
dispensing coffee, or
only dispenses a small
amount.
Coffee is dispensed
very slowly, and is of
poor quality.
Approx. 4 kg
1.2 litres
room temperature:
10°C ÷ 40°C
412 mm
148 mm
English

Troubleshooting

POSSIBLE CAUSE
The water tank is empty.
- Cold cups / espresso
cups.
- Scale build-up in
machine.
- The used capsule drawer
is full.
- Capsule stuck inside the
machine.
Heating up problems.
Incorrect programming of
amounts.
Button C was used with an
espresso capsule.

Technical data

See the data plate
on the bottom of the
machine.
Max. 15 bar
< 70dB A
10 capsules
319 mm
CURE
Fill the tank with fresh water. Press
a button to refi ll the circuit.When
the buttons are lit up steady, the
appliance is ready to use.
- Prewarm the cup.
- Descale.
- Empty the used capsule drawer.
- Remove the stuck capsule.
Turn the machine off, then on
again. If the problem persists,
take the machine to an Authorised
Service Centre.
Reprogram the amount for the
button.
See the section "Programming the
amount of coffee in a cup".
Use buttons A or B.
The materials and
objects in contact
with food products
comply with the
requirements of
European Regulation
1935/2004.
364 mm
23