Filtre par événement spécifique : Sélection de la liste des TRAPS triée par ordre de gravité
|
Information
This trap is sent upon completion of a UPS diagnostic test.
The UPS status is normal. Load protected by UPS.
Alarm cancelled. All alarms are disabled.
The UPS has cancelled the shutdown procedure to agent.
This trap is sent each time an alarm is removed from the alarm table.
The Input supply has been restored.
The communication between UPS and the agent has been restored.
NET VISION is restarting.
EMD Sensor Not over high temperature.
EMD Sensor Not over high humidity.
The input2 is restored.
EMD Sensor Not under low temperature.
EMD Sensor Not under low humidity.
The input1 is restored.
|
Avertissement
The UPS is operating on battery power.
The UPS output is in overload
The battery is in alarm.
The battery test has detected a weak battery.
Load supplied by automatic Bypass.
A warning message has been sent to shutdown agent.
This TRAP is sent each time an alarm is inserted into to the
alarm table.
Redundancy is lost.
The UPS has switched to battery back-up power.
The UPS internal temperature has reached the threshold.
A preventive alarm has been detected by the UPS.
A shutdown command has been sent to agent.
|
Critique
The UPS is about to switch off the output power.
The battery has been detected as discharged.
A critical alarm has been detected on the UPS.
UPS is no longer communicating with the agent.
The battery has been disconnected from the UPS.
The battery is near of the end of back-up time.
The load has been disconnected from the UPS.
EMD Sensor detected low temperature.
EMD Sensor detected low humidity.
EMD Input1 is active.
EMD Sensor detected high temperature.
EMD Sensor detected high humidity.
EMD Input2 is active.
NET-VISION 7.30 - SOCOMEC
Non disponible pour toutes les ASI
TRAP 22
TRAP 24 : L'alarme générale n'est plus présente.
TRAP 26 : Transmise si l'arrêt du serveur a été activé.
TRAP 4 : Entrée supprimée.
TRAP 23
TRAP 25
TRAP 27
TRAP 31
TRAP 35
TRAP 39
TRAP 29
TRAP 33
TRAP 37
TRAP 1 : Transmise toutes les minutes avec le temps d'au-
tonomie restant.
TRAP 6 : Le taux de charge d'utilisation en sortie est supé-
rieur à 100 %.
TRAP 11
TRAP16 : Échec du test.
TRAP 18 : Sur By-pass et pas en eco mode.
TRAP 20 : Transmise si l'arrêt du serveur a été activé.
TRAP 3 : Ajout d'une nouvelle entrée.
TRAP 7
TRAP 15 : Batterie en décharge – TRAP transmise une seule
fois.
TRAP 17
TRAP 19 (y compris alarme générale)
TRAP 21 : Transmise si l'arrêt du serveur a été activé.
TRAP 5 : Arrêt imminent
TRAP 9
TRAP 12
TRAP 14
TRAP 8
TRAP 10 : Charge batterie faible / fin de la durée d'autonomie.
TRAP 13 : Utilisation non alimentée ou en mode veille.
TRAP 28
TRAP 32
TRAP 36
TRAP 30
TRAP 34
TRAP 38
FR
45