Axis Q3505-VE Guide D'installation page 19

AXIS Q3505–VE Fixed Dome Network Camera
2. Slip the grooves in the black shield, over the screws on either side of the camera's optic
holder. Align the screws in the dome cover with the holes in the unit casing and tighten
using the Resitorx key TR20.
3. Remove the protective film from the dome cover.
Camera unit: AXIS Q3505–V
Complete the Installation
1. If required, attach the weather shield to the camera before you attach the dome cover.
To do this remove the two screws in the dome cover.
2. Make sure the rubber gasket sits securely on the dome cover, attach the dome cover to
the unit casing by tightening the 4 screws.
The installation is now complete.
Access the Product
Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/
Focus & Zoom
If you have selected Optical zoom for installation, follow the instructions below to set focus
and zoom.
To set focus and zoom:
1. Go to Video & Audio > Focus & Zoom.
2. On the Basic tab, set the zoom level using the slider. The buttons < and > move the zoom
position one step in either direction. The buttons << and >> move the zoom position in
multiple steps in either direction.
19