Automatic Washing System; Cup Heater (Optional); Using The Display Keyboard - La San Marco TOP 85 Emploi Et Entretien

Place a cup under the dispensing spout and select one of the keys indicated below.
Short programmed dose
Long programmed dose
Continuous manual dose
PROGRAMMED DOSE
By pressing one of the two programmed dose keys, the LED linked to the key of the selected dose flashes
while the hot water is dispensed; the other keys remain lit. Once the operation has been completed, the se-
lected key stops flashing.
Press the selected key again to interrupt the water flow before reaching the programmed dose.
DISPENSING IN START-STOP MODE
By pressing the continuous dose key, the LED flashes while the hot water is dispensed; the other keys remain
lit for the entire duration of the operation.
To interrupt the water flow in continuous mode, STOP the dose by pressing the same selected key.
The water flow in continuous mode is stopped automatically (if it is not stopped) after 40 seconds.

6.4 Automatic washing system

The automatic washing system allows the cleaning of coffee brewing groups.
Insert the filter holding cup with blind filter in the brewing group.
To start the washing cycle press the continuous dose key together with the short coffee single dose key for a
few seconds. The two keys are blinking and the cycle starts automatically.
At the end of the washing cycle the brewing group returns to its normal operating conditions.
Repeat the washing cycle for all the other groups in the same way.

6.5 Cup heater (optional)

The cup heater is used to increase heating of the upper cup support surface (by means of an electrical heating
element). Use the appropriate switch to activate or de-activate the cup heater. The cup heater heating ele-
ment is equipped with a working thermostat that controls the temperature of the cup support surface.

7. Using the display keyboard

53