Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Procedure
Prepare Installation Space
Create the cut-out in the countertop according to the
installation drawings. The angle of the cut surface to the
countertop must be 90°.
After creating the cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to your
countertop.
WARNING
To avoid electrical shock hazard, before installing
the cooktop, switch power off at the service panel to
prevent the power from being switched on
accidentally.
Cut out the countertop per the dimensions shown in the
section “Countertop Requirements”.
If there is no oven beneath the cooktop, put a non-
flammable intermediate floor (e.g. metal or plywood)
(10 mm) from the base of the cooktop. This will prevent
access to the base of the cooktop.
The distance from the intermediate floor to the power
supply connection for the appliance must be at least
(10 mm).
8
I n s t a l l a t i o n P r o c e d u r e
P r e p a r e I n s t a l l a t i o n S p a c e
/
"
3
8
/
"
3
8
Install the Cooktop
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
CAUTION
Sharp edges. Use protective gloves when installing
the cooktop.
1. Apply the included foam tape to the underside of the
cooktop.
2. Screw each one of the clips into the position shown in
the following image, so that they are free to rotate.
Publicité
Chapitres
Table des Matières
