Scope Of Supply; Technical Data Dh 40; Installation And Commissioning - Proxxon DH 40 Mode D'emploi

machined and thus guarantee maximum precision and
longevity.
The planer has an automatic feed unit. The workpiece is
therefore only pushed by hand into the infeed slot 9 for a
short distance. A knurled and spring-loaded roller then
draws the workpiece in, thus enabling even irregularly
shaped pieces of wood to be planed. After passing the
cutter shaft, the piece of wood is pushed out at the rear
by a rubber-coated roller through the outfeed slot 10.
The cutter shaft and the feed unit are driven by a powerful
electric motor, which transmits its movement to the rol-
lers and the shaft by means of gear wheels and toothed
belt drives. The respective linear and rotational speeds
are exactly matched to one another.
The height of the planing table 4 and thus the planing
thickness can be conveniently and reliably adjusted by
means of the large hand wheel 2 on the top of the
housing.
Caution!
The planer is equipped with a so-called re-start protection
facility. If the supply is interrupted for a short time during
operation, the planer will not re-start automatically for
safety reasons. However, in this case, the planer can be
started normally by means of the "on" switch.

Scope of supply

1 off Thickness planing machine DH 40
1 off Pin for height adjustment hand wheel
1 off Operating manual

Technical data DH 40:

Voltage:
Power:
Max. pass-through height:
Max. pass-through width:
Length of planing table:
Swept diameter of shaft:
Planing cutter length:
Cutters:
Planing shaft speed on no-load:
Max. planing reduction:
Feed speed:
Sound pressure level:
Sound power level:
Vibration:
- 12 -
220 – 240 Volt,
50/60 Hz
200 Watt
KB 15
40 mm
80 mm
232 mm
48 mm
82 mm
2-off HSS reversible
cutters
6000 rpm
0.8 mm
4.8 m/min
ca. 85 dB(A)
ca. 98 dB(A)
≤ 2.5 m/s
2
Dimensions:
Length:
Height:
with hand wheel:
Width:
Weight:
1. For use in enclosed rooms only!
Please do not dispose off the machine!

Installation and commissioning

Caution!
Please check the thickness planer immediately for
possible transit damage. Damage to the packaging may
indicate incorrect handling during shipping. It is essential
that transit damage should be reported immediately to the
dealer or to the shipping company concerned.
Note:
The foundations for the erection of the planer must be
firm, clean and dry.
1. To erect the planer, remove the machine from the
packaging and place
foundation.Ensure that the machine is standing safely
and that it cannot fall during operation.
2. It is recommended that the machine be bolted to the
foundations. There are 4 holes in the die-cast
aluminium feet for
accommodate M5 Allen screws (not included in the
scope of supply).
3. Screw the pin 1 (Fig. 2) onto the hand wheel of the
planer using an Allen Key.
Caution:
Before plugging in the mains plug, please check whether
the information on the rating plate corresponds with the
characteristics of your local electricity supply.
4. Plug in the mains cable.
280 mm
232 mm
300 mm
225 mm
ca. 8 kg
on a flat and
this purpose, which
level
will