ResMed AirFit P10 Guide De L'utilisateur page 11

3. Holding the top of the mask tube, squeeze and pull the pillows away
from the mask frame.
4. Remove the headgear from the frame by pulling the fabric to reveal
each buttonhole, then sliding the fabric off the end of each arm of
the frame.
Reassembly
1. With the gray side of the headgear facing out, thread the arms of the
mask frame into the buttonholes of the headgear. Secure the
headgear by pulling it over the edge of the frame closest to the nasal
pillows. Holding the mask frame, stretch the headgear lightly to
ensure it is securely attached.
2. Attach the pillows to the mask frame by inserting the top and
bottom clips into the correct slots.
3. Ensure the inner walls of the nasal pillows are not compressed or
collapsed. If required, a light squeeze can return each nasal pillow to
the correct shape.
4. Connect the AirMini tubing to the vent module by pushing the ends
together and twisting until it locks in place.
5. To add optional humidification, inset the HumidX/HumidX Plus into
the vent module. Connect the mask tube to the vent module by
pushing the ends together and twisting until it locks in place.
Cleaning your mask at home
Follow the cleaning instructions in this guide to maintain performance
and safety of the mask.
English 5