ResMed AirFit P10 Guide De L'utilisateur page 10

Fitting
To set up your AirMini machine, refer to the AirMini user guide. Once
you have set up your AirMini, follow these steps to fit your mask.
1. Align your left (L) and right (R) pillows with your left and right
nostrils. Pull the headgear straps over your head. Your lower
headgear strap should sit comfortably at the back of your head. The
top strap should sit comfortably on your crown.
2. To ensure a comfortable fit, briefly pull your mask away from your
nose and reseat the pillows. Ensure the nasal pillows fit securely
into your nostrils with both pillows positioned upright.
3. Your mask is now fitted and ready to use. When the device is
running, a light breeze should be felt near the venting area around
the tube connection. To inspect the vent, place a finger close to the
connection area and feel for air. Do not allow the venting area to
become blocked.
Adjustment
To achieve a comfortable fit, adjust the upper and lower headgear
straps - spread straps apart to loosen or draw closer together to tighten.
For additional adjustment, you may use your AirFit P10 Headgear clips.
Refer to your Headgear clips instruction sheet for assistance.
WARNING
Do not overtighten the headgear straps
Removal
To take off your mask system, pull the mask and headgear by the split-
strap, up and over your head.
Disassembly
1. Disconnect the mask tube from the vent module by gently twisting
it and pulling apart. If you are using the HumidX or HumidX Plus,
remove it from the vent module.
2. Disconnect the vent module from the AirMini tubing by gently
twisting it and pulling apart.
4