Installation Of The Davey Variable Speed Pump; Power Connection - Davey SilensorPRO SP200BT Instructions D'installation Et D'utilisation

1. INSTALLATION OF THE DAVEY VARIABLE SPEED PUMP

The SilensorPRO should be located as close to the water as practicable and mounted on a firm base in a
well drained position, high enough to prevent any flooding. It is the installer/owner's responsibility to locate
the pump such that the nameplate can be easily read and the SilensorPRO can be readily accessed for
service. It is recommended that the SilensorPRO is protected from the weather. Enclosures should be
ventilated to prevent condensation build-up.
Failure to follow these instructions and comply with all applicable codes may cause
serious bodily injury and/or property damage.
This pump requires professional expertise for installation and maintenance. The
installation of this product should be carried out by a person knowledgeable in
swimming pool plumbing requirements and who follows the installation instructions
provided in this manual.

Power connection

IMPORTANT INFORMATION Your SilensorPRO is double insulated to water circuit.
If equipotential bonding structure is required, then an Equipotential Bonding Point
is provided. (Please refer to your local statutes and/or regulations for AS/NZ 3000
equivalent wiring standards).
CAUTION! In the interest of safety, we advise that all brands and types of pool pumps
must be installed in accordance with AS/NZS 3000, known as the national wiring
rules, or equivalent local standards. All electrical installations must be carried out by
a qualified electrician. Davey recommends that all installations are fitted with earth
leakage, or residual current protection devices. Rated residual operating current not
exceeding 30mA.
WARNING! Ensure that an electrical isolation switch is located with easy access so that
the pump can be switched off in an emergency.
F NFC C 15-100
D DIN VDE 0100-702
A OVE 8001-4-702
E UNE 20460-7-702 1993, REBT ITC-BT-31 2002 M
IRL IS HD 384-7-702
I CEI 64-8/7
LUX 384-7.702 S2
NL NEN 1010-7.702
The SilensorPRO is suitable for connection to a nominal 220 – 240 volt 50/60Hz power supply and is
equipped with a flex cord. If a power outlet is not available within 3 metres of the pump, a 3-pin power point
in a safe, dry place may need to be provided by an electrician. Extension cords are unsafe around pools and
should be avoided. If the supply cord of the SilensorPRO is damaged it must be replaced by Davey, or an
approved agent with genuine Davey spares.
The SilensorPRO incorporates motor overload detection designed to protect the motor from overheating.
If the motor gets too hot during operation, its operating speed will reduce to bring it within an acceptable
operating temperature and then will speed up to the originally set speed.
To reset the motor, switch the power off for 30 seconds, and then return the power from the mains switch.
GB BS7671:1992
EW EVHS-HD 384-7-702
H MSZ 2364-702:1994/MSZ 10-533 1/1990
MSA HD 384-7-702.S2
PL PN-IEC 60364-7-702: 1999
CZ CSN 33 2000 7-702
SK STN 33 2000-7-702
SLO SIST HD 384-7-702.S2
3
English