Dimensions; Using Your Silensorpro With A Salt Water Chlorinator; Operating Your Suction Pool Cleaner - Davey SilensorPRO SP200BT Instructions D'installation Et D'utilisation

Dimensions

C
A
E
A B C
305mm 670mm 320mm

9. USING YOUR SILENSORPRO WITH A SALT WATER CHLORINATOR

Chlorinators require a minimum flow rate through the chlorinator cell for best efficiency and cell life. Please
refer to your chlorinator guide as a reference for the flow required by your pool system. Ensure flow rate is
enough to cover your chlorinator cell plates completely at all times of operation.

10. OPERATING YOUR SUCTION POOL CLEANER

Before installing or purchasing a pool cleaner for use with your SilensorPRO, it is important to know the
minimum flow rates required for it to operate effectively.
To operate a suction pool cleaner:
• Activate the High Flow setting (10) and allow the pump to fully prime by running for around 2 minutes. You
will know the pump is primed when you can see a strong flow of water through the clear leaf basket lid.
• When all air is expelled from the leaf basket, connect the pool cleaner hose firmly into the skimmer plate or
dedicated wall suction.
• Select the speed setting that enables best performance from your suction pool cleaner. Speed 3 to 7 should
be ample for most cleaners, however if the cleaner requires better performance, select speeds 7 to 10.
• The cleaner should only be connected for as long as is required to clean the surface of your pool. When
cleaning is complete, disconnect the cleaner and remove the skimmer plate from the skimmer box.
• Reactivate the most efficient speed setting for daily filtration. Speeds 1 to 4 is recommended.
NOTE: To get optimum energy efficiency from your SilensorPRO, DO NOT keep the
suction pool cleaner connected when cleaning is not required.
NOTE: If the SilensorPRO is hard-wired into a time clock, or another automatic control,
the wiring should be removed by a qualified technician.
• Close the water valves on the pool return and the SilensorPRO inlet pipework;
• Remove the discharge & suction barrel unions taking care not to lose the o-rings;
• Move the pipework with the barrel unions attached until the SilensorPRO can be pulled clear.
NOTE: When making any enquiries about your SilensorPRO be certain to quote the
model number from the nameplate located on the motor.
B
D
D E F
350mm 65mm 230mm
G
F
H
I
G H
380mm 200mm 250mm
17
Mounting
Inlet/Outlet
I Holes
PVC
Diameter
10mm 50/63
Net
Weight
(kg)
14
English