GE JS905 Manuel Du Propriétaire page 30

Problem
Oven will not self-clean
"Crackling" or
"popping" sound
Excessive smoking
during a clean cycle
Oven door will not
open after a
clean cycle
Oven not clean after
a clean cycle
"LOCKED" flashes
in the display
"LOCKED" light is on
when you want to cook
"F— and a number
or letter" flash
in the display
Possible Causes
The oven temperature is
too high to set a self-clean
operation.
Oven controls improperly set. • See the Using the self-cleaning oven section.
This is the sound of the
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive soil.
Oven too hot.
Oven controls not properly set. • See the Using the self-cleaning oven section.
Oven was heavily soiled.
The self-clean cycle has been • Close the oven door.
selected but the door is not
closed.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
You have a function
error code.
If the function code repeats.
What To Do
• Allow the oven to cool and reset the controls.
• This is normal.
• Press the CLEAR/OFF pad. Open the windows to rid
the room of smoke. Wait until the LOCKED light goes
off. Wipe up the excess soil and reset the clean cycle.
• Allow the oven to cool below locking temperature.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
• Press the CLEAR/OFF pad. Allow the oven to cool.
• Press the CLEAR/OFF pad (OFF pad on Canadian
models). Put the oven back into operation.
• Disconnect all power to the range for at least
30 seconds and then reconnect power. If the
function error code repeats, call for service.
ge.com
29