Table Des Matières - Yamaha NS-SW210 Mode D'emploi

• VOLTAGE SELECTOR
(Asia and General models only)
The voltage selector switch on the rear panel of this
unit must be set to your local main voltage BEFORE
plugging this unit into the AC main supply. Voltages
are 110-120/220-240 V AC, 50/60 Hz.
This unit is not disconnected from the AC power
source as long as it is connected to the wall outlet, even
if this unit itself is turned off. In this state, this unit is
designed to consume a very small quantity of power.
This unit features a magnetically shielded design,
however, there is still a chance that placing it too close
to a TV set might impair picture color. Should this
happen, move this unit away from the TV set.
For U.K. customers
If the socket outlets in the home are not suitable for the
plug supplied with this appliance, it should be cut off and
an appropriate 3 pin plug fitted. For details, refer to the
instructions described below.
Note: The plug severed from the mains lead must be
destroyed, as a plug with bared flexible cord is hazardous
if engaged in a live socket outlet.
SPECIAL INSTRUCTIONS FOR U.K. MODEL
IMPORTANT:
THE WIRES IN MAINS LEAD ARE COLOURED
IN ACCORDANCE WITH THE FOLLOWING
CODE:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows: The wire which is coloured BLUE
must be connected to the terminal which is marked
with the letter N or coloured BLACK. The wire which
is coloured BROWN must be connected to the
terminal which is marked with the letter L or coloured
RED. Make sure that neither wire is connected to the
earth terminal of a three pin plug.
For Canadian Customers
To prevent electric shock, match wide blade of plug to
wide slot and fully insert.
This Class B digital apparatus complies with Canadian
ICES-003.
CONTENTS
FEATURES......................................................................... 2
SUPPLIED ACCESSORIES............................................... 2
ATTACHING THE NON-SKID PADS ............................. 2
PLACEMENT..................................................................... 3
CONTROLS AND THEIR FUNCTIONS.......................... 3
CONNECTIONS................................................................. 4
Connecting to line output (pin jack) terminals of the
amplifier..................................................................... 4
Plug in the subwoofer to the AC outlet .............................. 4
ADJUSTING THE SUBWOOFER BEFORE USE ............... 4
Frequency characteristic ............................................ 4
ADVANCED YAMAHA ACTIVE SERVO
TECHNOLOGY II.............................................................. 5
TROUBLESHOOTING ...................................................... 6
SPECIFICATIONS ............................................................. 7
1
En