Cembre B1350-C Notice D'utilisation Et Entretien page 7

To replace the battery, remove it by pressing the release button (7) (Ref. to Fig. 1),
then insert the new battery, sliding it into the guides until it locks.
The display shows the operational parameters of the tool; to customise them proceed
as described in § 2.7.
Select the appropriate die set for the connector.
Insert one die into the upper seat of the tool head (Ref. to Fig. 2) until it is locked by
retaining pin (13), to ease the die insertion keep release pin (12) depressed.
Insert one die into the seat on the ram until it is locked by retaining pin (15).
To ease this operation, operate the tool (see § 2.2) to advance the ram (11) 8-10 mm
(0.3 - 0.4 in.) and keep release pin (14) depressed.
Insert the conductor into the connector (Ref. to Fig. 3).
Position the connector between the dies and ensure the correct location of the
crimp (Ref. to Fig. 4).
NOTE: when more compression
is required, proceed according
to the sequence and direction
indicated in the fi gure.
2.2) Die advancement
Press operating button (4) (Ref. to Fig. 4) to activate the motor-pump and advance
the lower die.
To halt the advancement, release operating button (4) and the motor will cut out.
Make sure the dies are exactly positioned on the desired crimp point otherwise
re-open dies following instructions as per § 2.4 and reposition the connector.
2.3) Compression
By keeping operating button (4) pressed, the motor continues to operate: the ram
will gradually move forward until the two dies touch.
The motor will stop automatically when the set pressure and the developed force
have been reached.
To perform proper compression, press and hold the operating button (4) until
the motor stops automatically.
7
terminal
2
1
2
1
connector
1
2