Cembre B1350-C Notice D'utilisation Et Entretien page 11

3 SEC.
The capacitive menu selection button may not work if touched using
objects or when wearing gloves, therefore always operate it using a bare fi nger.
4.2)
SELECTION SCREENS: control parameters that cannot be set as automatic
upon start-up of the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights (factory setting LED ON)
LED
ON
LED
OFF
Return to original factory settings / fi rmware version
When the 'RESET' screen is displayed, return the tool to its factory setting by operating
the touch button for at least 3 seconds; a beep will confi rm the setting.
RESET
The RESET screen also shows the fi rmware version of the circuit board.
SW:S1J41AH
4.3)
WARNINGS: these appear during operation and notify the operator of the status
of the tool:
LOW BATTERY: replace the battery.
BATTERY
NOTE: when the battery voltage falls below a minimum safety threshold, the tool
will not start; although it is still possible to end the work cycle in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools
BATTERY
down.
NO. OF CYCLES TO MAINTENANCE REACHED:
10013
the tool continues to work however, it is recommended that it is sent to Cembre
for a complete overhaul (see § 5).
NOTE: this screen, together with a beep, will reappear when the tool has been
idle for 30 seconds.
11
To make a selected screen operational and appear at each start-
up of the tool, operate the touch button for at least 3 seconds; a
continuous beep will confi rm the setting.
3 SEC.
When the screen is dis-
LED
played, touch the button
OFF for at least 3 seconds to
deactivate for reactivate
operation of the LED Work-
LED
lights during tool use;
ON
a continuous beep will con-
fi rm the setting.