Stanley RL HW Instructions page 14

it is preferable to use the remote whenever possible to
perform functions (when available).
• Laser tool is Auto-Levelling by default.
• Tilt Warning is ON by default when laser tool leaves the
manufacturer.
• Tilt Warning is only available in the Auto-Levelling modes.
Tilt Warning is not available while in Manual Mode.
Power
• Press to turn laser tool ON / OFF.
• When powered ON, Tilt Warning is ON by default
(default setting can be changed).
• When powered ON, Laser tool begins Auto-Levelling.
• When Auto-Levelling has completed laser will rotate at
last used RPM speed setting.
Tilt Warning (not available in Manual Mode)
• When powered ON, Tilt Warning is ON by default.
• When powered ON, press to turn Tilt Warning
ON / OFF.
• With Tilt Warning ON, laser tool will indicate with LED
/ LCD and blinking laser beam when the laser tool has
sensed any movement.
• If an alarm has been triggered, press
• When reset, the laser tool begins Auto-Levelling. Check
alignment with original target.
Tilt Warning Default Setting
• When powered OFF, press and hold
by .
• Release both keys.
• If Tilt LED / Icon is ON, default setting is ON. If Tilt LED /
Icon is OFF default setting is OFF.
• Laser tool begins Auto-Levelling as done when normally
powered ON.
• Repeating the steps will toggle ON / OFF the Tilt
Warning default setting.
Manual Mode
• When powered ON, press and hold
seconds to turn ON / OFF Manual Mode.
• Auto-Levelling is OFF in Manual Mode.
14
• Laser tool can be manually positioned at any angle.
• When Manual Mode is turned OFF, laser tool begins
Auto-Levelling as done when initially powered ON.
Calibration Mode - see Accuracy Check and
Calibration section
Manual Slope Mode
(For RL HW / RL HW+ substitute
is referenced below)
• When powered ON, press
ON, Auto-Levelling OFF.
(For RL HGW needs to be pressed and held for
≥ 3 seconds to enter Manual Mode prior to pressing
noted above)
• LED / LCD will indicate "X" axis adjust. Press
to adjust axis.
to reset.
• LED / LCD will indicate when at maximum slope angle.
The axis will not move any further in that direction.
• Press again to set the "X" axis and / or proceed to
the "Y" axis adjust.
followed
• LED / LCD will indicate "Y" axis adjust. Press
to adjust axis.
• LED / LCD will indicate when at maximum slope angle.
The axis will not move any further in that direction.
• Press again to set the "Y" axis and / or proceed to
use of laser tool in Manual Slope Mode.
• "X" and "Y" axis are now set at manually adjusted
slopes.
• To turn Manual Slope Mode OFF, press and hold
for ≥ 3 seconds.
for ≥ 3
• When Manual Mode is turned OFF, laser tool begins
Auto-Levelling as done when initially powered ON.
77-496 / 77-429 / 77-439 / 77-497 / 77-427 / 77-441
where ever
. Manual Mode turns