Aux In; Sleep; Alarm - auna Connect 150 SE Mode D'emploi

EN
40
stations, this may result in a poor signal-to-noise ratio (hiss). To play
weak stations in mono, select FM weak reception: Listen in mono only
and then YES.
BT
In BT mode, you can turn on the BT of your BT device. Go to the menu and
turn BT discoverable. From your BT device, search the radio CONNECT
150SE to pairing. When it is waiting for pairing, there is a blinking BT icon at
the bottom. If the pairing is successful, the BT icon becomes steady.
Control the music playback from your BT device.
Control the music playback from your BT device. Press / on the remote
control to go back to forward track or go to next track. Press
pause the track.
To disconnect from the radio, press and hold BT PAIR on the remote control.

AUX IN

AUX in mode plays audio from an external source.
Turn the volume low on both the radio and, if adjustable, the audio source
device.
Enter AUX mode, then adjust the volume as required.

SLEEP

To set the sleep timer, select Sleep under Main menu. Or press
remote control to set. Choose from Sleep OFF, 15, 30, 45 or 60 minutes
and confirm. Once you select a sleep period, the system returns to the now
playing screen.

ALARM

There are two versatile wake-up alarms with snooze facility. Each alarm can
be set to start in a particular mode.
Select Alarms under Main menu to set or change an alarm. Alternately,
press ALARM on the remote control to configure.
After setup all the parameters, select Save to activate. The screen shows
active alarms with an icon at the bottom left.
At the set time, the alarm will sound. To temporarily silence, press any
key excepted pressing the VOLUME knob or pressing
 to play or

on the
or ALARM on the