Weidmüller PT 100/2 Notice D'utilisation page 17

3.1 Mounting onto TS 35 DIN rails
(Page 63, Fig. 1)
3.2 Pluggable electronic components for range alteration
(depending on model)
(Page 63, Fig. 2)
1. Remove connector, (depending on model either screw-type
or tension clamp).
2. Press locking clips on both sides of the enclosure.
3. Pull out the circuit board.
Warning!! The circuit board can only be inserted in one position.
The connectors have been coded by the manufac-
turer, ensuring that they cannot be reversed.
17