Royal Sovereign ARP-908 Guide D'utilisation page 7

INSTALLATION
Part 2: Exhaust Hose Installation
•
The two exhaust duct connectors tighten on the ends of the exhaust duct (See Fig. 1).
•
Slide the square side of the exhaust duct connector into the opening at back of the air
conditioner (See Fig. 2 and Fig. 3).
•
The exhaust hose can extend up to approximately 59 in. (150 cm.).
Part 3: Window Seal Plate Installation
•
The window seal plate can be installed horizontally or vertically. The window seal plate can fit in
windows with a minimum width of 23.5 in (60 cm.) and a maximum width of 59 in. (150 cm.).
•
Open the window and place the window seal plate on the inside edge of the window.
•
Adjust the window seal plate to the width of the window. Once secure, close the window.
•
Connect the oval side of the exhaust duct connector to the window seal plate.
7