Black & Decker LPHT120 Manuel D'instruction page 8

CoMPoNeNts
Before using your Pole Trimmer familarize yourself with all operating
and safety features.
a
5
B
10
1. Trigger Switch
2. lock Button
3. Battery
4. Foam Gripper
5. Threaded Pole
6. Threaded Sleeve
4
8
9
7
7. locking latch
8. Hand Guard
9. Five Position Head
10. Trimmer Blade
ChArGING ProCeDUre
1. Plug the charger into an appropriate outlet before inserting the
battery pack.
2. Insert the battery pack into the
charger as shown in figure 1.
3. The green LED will flash indicating
2 that the battery is being charged.
4. The completion of charge
is indicated by the green leD
1
remaining on continuously. The
pack is fully charged and may
be used at this time or left on the
3
charger.
recharge discharged batteries
as soon as possible after use or
6
battery life may be greatly diminished. It is recommended that the
batteries be recharged after each use.
IMPortANt ChArGING Notes
1. longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 60°F and 80°F
(16°- 27°C). DO NOT charge the battery pack in an air temperature
below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important
and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while
charging. This is a normal condition, and does not indicate a problem.
To facilitate the cooling of the battery pack after use, avoid placing
the charger or battery pack in a warm environment such as in a metal
shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. check current at receptacle by plugging in a lamp or other
appliance
b. check to see if receptacle is connected to a light switch which
turns power off when you turn out the lights.
c. Move charger and battery pack to a location where the
surrounding air temperature is approximately 60°F and 80°F
(16°- 27°C)
8
1