Black & Decker LPHT120 Manuel D'instruction page 10

To attach the handle module to the
trimmer head module:
1. align the groove on the outside
of the coupling end of the handle
module (A) with the tongue on the
inside of the coupling end of the
trimmer head module (B). see
figure 4. Push the two sections
completely together.
2. Slide the threaded sleeve (6) figure
5 on the trimmer head module down
as far as possible and rotate the
sleeve clockwise until it stops and
completely covers the orange threads
as shown in figure 6.
WArNING:
Always check to
make sure that the sleeve is
completely threaded on and that the
orange threads are no longer visible. Not threading the sleeve
completely on could result in the modules becoming disconnected
creating a hazardous condition. Periodically check the connections to
insure that no orange threads are visible.
DIsAsseMBly
Detaching trimmer head Module
WArNING:
sharp moving blade. to prevent accidental operation,
insure that battery is disconnected from the handle before performing the
following operations. Failure to do this could result in serious personal injury.
When detaching the modules rest the handle module on the ground
and grasp the center of the trimmer head module with
one hand figure 7. Use your other hand to loosen the
threaded sleeve figure 8 and then pull the two halves
apart.
8
4
B
a
Groove
5
6
7
10
oPerAtING the Pole trIMMer
WArNING:
read and understand all instructions. Failure to
follow all instructions listed below may result in electric shock, fire and/
or serious personal injury.
Connecting the Battery
Place the battery in the tool as shown in figure 9 and be certain that it is
inserted fully into the tool cavity until it "clicks" into place. To remove the
battery from the tool, press down on the release button on the back of
the battery (figure 10) and slide out.
9
Pivoting the trimmer head
The trimmer head pivots 180 degrees and can be locked into 5 different
positions within that range. To avoid being pinched, wear gloves and
hold unit as shown below.
Before connecting the battery to the unit, be sure the trimmer head is
locked into position.
To pivot the trimmer head:
1. Press in on the locking latch (7) and
raise the trimmer head as shown in
figure 11.
2. lock the trimmer head into any of
the 5 positions. Check to make
sure that trimmer head is locked
into position by trying to move the
motor housing. If it is not locked,
rotate it to the closest lock position.
10
11