ims PRO TITAN 400 DC Mode D'emploi page 30

Advice :
The choice of frequency:
- If welding with TIG electrodes, then F(Hz) synchronised to the gesture,
- If thin plate without TIG electrodes (< 8/10 mm), F(Hz) >> 10Hz
- If special metal requiring a welding pool sweep for degassing, then F(Hz) >> 100Hz
TIG WELDING PROCESSES
• Spotting- SPOT
This mode is recommended to pre-assemble workpieces before welding.
The adjustable spot weld duration enables control of the weld time for better spot welding results and a non-oxidised spot (accessible via the
advanced menu).
• Spotting - TACK (TIG DC)
This mode can also pre-assemble workpieces, but in two phases : first phase is DC pulse which concentrates the arc for enhanced penetration, fol-
lowed by a DC standard phase which enlarges the arc and the weld pool for a good spot.
The adjustable duration of each phase enables control of the weld time for better spot welding results and a non-oxidised spot (accessible via the
advanced menu).
30
IMS TITAN 400 DC
I
%I
A
%t
Hz
A
t(s)
I
%
-
TIG HF TIG
lift
OK
MMA PULSE
2T 4T 4T
LOG %I SPOT
TIG SPOT PROCESS
The grey areas are not useful for this mode.
I
%I
A
%t
Hz
A
t(s)
I
%
-
TIG HF TIG
lift
OK
MMA PULSE
2T 4T 4T
LOG %I SPOT
TIG TACK Process
The grey areas are not useful for this mode.
MADE IN FRANCE
A
V
Hz
kJ
+
JOB
setup
E. TIG
TACK PULSE
MADE IN FRANCE
A
V
Hz
kJ
+
JOB
setup
E. TIG
TACK PULSE
UK