Set-Up; Service - Velp Scientifica OHS 200 ADVANCE Manuel D'instructions

7.5 Set-up

➢
➢
Start Mode
➢ Run: when the instrument is switched on, it restarts to work with the last set point set.
➢
➢
➢
➢
Wi-Fi Set-up
➢
➢
Wi-Fi Information
➢
➢
➢
➢
➢
➢
➢
➢
Display
.
➢
➢
➢
Time & Date
➢
➢
➢
Temperature Unit
➢
Language
➢

7.6 Service

➢
Reset Torque
➢
➢
➢
Real Torque
➢
➢
Pt100
➢
Alignment
The decision of the instrument's restart mode in case of blackout or power loss.
Enter in the menu, rotate speed control knob (C) to select Stop or Run. Click to confirm.
➢ Stop: when the instrument is switched on, it's requested a click of the control knob to start stirring.
If Stop is selected, A appears on the blue upper bar (2).
If Run is selected, B appears on the blue upper bar (2).
It allows to switch on wi-fi module for IoT transmission.
Enter in the menu, rotate speed control knob (C) to select ON or OFF. Click to confirm.
When wi-fi is ON, appears on the blue upper bar (1).
It describes all wi-fi information (MAC address, Power of signal, wi-fi name).
It allows for brightness to be set or if torque and temperature should be displayed on the main screen.
Enter in the menu and scroll with speed control knob (C). Click to enter in submenus.
Brightness: enter in this submenu, rotate speed control knob (C) to select the desired brightness value. Click
to confirm.
Brightness can be set by 10% steps.
Torque: enter in this submenu, rotate speed control knob (C) to choose between ON or OFF if the display of
torque on the main screen is desired or not. Click to confirm.
Temperature: enter in this submenu, rotate speed control knob (C) to choose between ON or OFF if the
display of temperature on the main screen is desired or not. Click to confirm
If torque and temperature are displayed on the main screen, the display menu appears as in
When temperature is displayed but Pt100 probe is not inserted in the instrument, the main screen appears
as in Figure 19.
Figure 9. Torque and
temperature shown
It allows to set hour and date.
Enter in the menu and select Set Time. Rotate speed control knob (C) till the right time. Click to confirm.
Return to the previous page clicking BACK button.
Select Set Date. Rotate speed control knob (C) till the right day. Click to confirm
Repeat the operation for month and year.
It allows to choose temperature unit that has to be visualized between °C and °F.
It allows to select the interface language.
Enter in the menu, rotate speed control knob (C) to select language. Click to confirm.
It allows to reset the current torque.
Click with the speed control knob (C) to reset torque.
It allows to return to real torque value.
Click with the speed control knob (C) to return to real torque value.
Negative torques can't be visualized anymore.
It allows for the alignment of the Pt100 probe to a reference thermometer.
Enter in the menu, rotate speed control knob (C) to select the desired alignment value (from -10.0°C to
10.0°C). Click to confirm.
Figure 10. Main without
temperature probe
15
Figure 18.