Methods; Method Set-Up - Velp Scientifica OHS 200 ADVANCE Manuel D'instructions

Timer
Gear *
* Graph for models OHS 100 and OHS 60
** Not visualized for models OHS 100 and OHS 60

7.2 Methods

In this submenu is possible to set 10 different methods. For OHS 200, 10 different methods for each speed range.
Once set, a method becomes white in the method list and a blue bar appears on the left.
Press START to begin the method.
Figure 9. Methods
When a method is working, on the main screen the current method (15) is shown.
It's not possible to modify speed, gear, or the timer.
It's possible to navigate in menu.
To stop a method before its end, enter in the method list and click STOP.
7.2.1

Method set-up

In each method it's possible to set parameters in
on the left as shown in Figure
Figure 3.
Service Reset Torque
Real Torque
Pt100 Alignment
Check Locking Ring
Reset Parameters
Update Software
Counter
Ermes
Motor Calibration
Figure 12. Once method parameters are set, they are highlighted in white with a blue bar
13.
Method parameters
Figure 2. Methods set
Figure 4.
12
Figure 11.
Method parameters set
Stop Method