Publicité
Les langues disponibles
Les langues disponibles
Note: There is a short delay in the motor starting after engaging the switch lever 1.
Stopping
Release the switch lever
If the mower is not going to be used immediately fit isolator key as shown in the storage position.
The machine is fitted with a blade brake. This safety feature stops the blade from rotating in a few seconds.
Inserting the Battery
Lift up battery cover .
Fit battery , when correctly fitted a "click"will be heard.
If the mower is not going to be used immediately fit isolator key as shown in the storage position.
Removing the Battery
Lift up battery cover .
Remove isolator key .
Remove the battery .
Meaning of the Indication Elements
Charging Procedure
The charging procedure starts as soon as the mains plug of the battery charger is plugged into the socket outlet
and the battery is inserted into the charging compartment .
Due to the intelligent charging method, the charging condition of the battery is automatically detected and the
battery is charged with the optimum charging current, depending on battery temperature and voltage.
This gives longer life to the battery and always leaves it fully charged when kept in the charger for storage.
Control of the charging procedure is indicated via the charge control LED .
LED status display ：
Charger AC power access, the battery is not installed (no load condition): bright red LED.
Rapid-charging Procedure
Access to the normal battery charging, the green LED 18 flashes.
Note: The rapid-charging procedure is only possible when the battery temperature is within
the allowable charging temperature range.
Battery Charged
Fully charged, the green LED lit. This rechargeable battery can be used directly.
No charging procedure possible
Abnormal situation, the red LED flashes.
The charging procedure can not be started and the battery cannot be charged (see "Trouble-shooting").
Working Advice
Battery Charge-control Indication
The battery is equipped with a charge-control indicator which indicates its charge condition. The charge-control
indicator consists of 3 green LED.
Press the button to start charging control indicators ,Release, the charge control indicator goes out. In the state
of charge can also check the battery is removed.
LED Indicators
Continuous lighting of 3 green LED
Continuous lighting of 2 green LED
Continuous lighting of 1 green LED
Flashing of 1 green LED
When no LED lights up after actuating the button, the battery is defective and must be replaced.
For safety reasons, the charge condition of the battery can only be checked when the product is at a standstill.
During the charging procedure, the three green LED light up one after the other and briefly go out. The battery is
fully charged when the three green LED light up continuously. The three green LED again approx 5minutes after
the battery has been fully charged.
Battery Capacity
≥2/3
≥1/3
≤1/3
Reserve
63
Publicité
