Aqua Marina BETTA BE-312 Manuel De L'utilisateur page 12

SEAT INSTALLATION
BETTA/ RIPPLE
1. Inflate the seat with the foot pump.
2. Once seat position is confirmed, connect the seat straps to the D-rings by using
strap buckles. Attach the upper straps to the D-rings forward of each seat.
LAXO/ MEMBA/ STEAM
1. Attach the seat to the kayak floor with Velcro.
2. Once seat position is confirmed, connect the seat straps to the D-rings by using
strap buckles. Attach the upper straps to the D-rings forward of each seat.
NOTE:
1. It is important to place the seat in the right place to evenly balance the boat
when in the water. A solo paddler should be slightly aft of the boat's center.
With two paddlers, the heavier one should sit toward the rear.
2. Seat position could be easily adjusted by clipping strap buckles to different
D-rings, and strap buckles may be clipped to the same D-ring if needed.
12