Aqua Marina BETTA BE-312 Manuel De L'utilisateur page 11

4. Start pumping air into the side chambers and the floor of the kayak according to the
inflation sequence as suggested in the below table.
NOTE: For STEAM/MEMBA/RIPPLE, remember to install the air deck floor before inflation.
11" Foot Pump for BETTA/ LAXO/ RIPPLE
Keep inflating until the required air pressure is reached. DO NOT OVERFILL!
TIP: Working pressure of each part should NOT exceed the maximum as below.
Inflation Sequence
BETTA
Floor → Side Chambers
LAXO Floor → Side Chambers
RIPPLE Floor → Side Chambers
MEMBA Side Chambers → Floor
STEAM Side Chambers → Floor
*IMPORTANT!
For BETTA, please use the transparent scale (come with the
repair kit bag) to check if the kayak floor is properly inflated.
The black line should NOT be longer than the MAX. scale.
WARNING: Do not leave your kayak/canoe under direct sunlight as this may cause over-inflation!
PARTIALLY INFLATE THE SIDE CHAMBERS AND THE KAYAK FLOOR AND CHECK
THAT THE FLOOR IS TUCKED UNDERNEATH THE SIDES.
5. Once inflated, firmly cap each valve.
NOTE：After multiple times of inflation – deflation, there may be slight displacement of the valve.
Replace it to the correct position when deflated. Then inflate to required air pressure to use.
TIP: If the pump piston starts to squeak, apply some spray silicone on the piston shaft.
16" Hand Pump for MEMBA/ STEAM
Side Chambers
1.45psi / 0.1bar
1psi / 0.07bar
1psi / 0.07bar
1psi / 0.07bar
1.45psi / 0.1bar
11
Floor
Refer to the transparent scale.*
1psi / 0.07bar
1psi / 0.07bar
4.35psi / 0.3bar
4.35psi / 0.3bar
IMPORTANT!
Please use the scale
transparency (come with the
repair kits bag) to check if the
kayak floor is properly
inflated. The black line in
below should NOT be longer
than the MAX. scale.