Cisco Systems Linksys WKPC54G Guide D'installation Rapide page 3

D
Repeat step C to connect
additional PCs or other network
devices to the Router.
E
Connect a different Ethernet
network cable from your cable
or DSL modem to the Internet
port on the Router's back
panel. This is the only port that
will work for your modem
connection.
F
Power on the cable or DSL
modem.
G
Connect the AC power
adapter to the Router's Power
port and the other end into an
electrical outlet.
H
Make sure the Power and
Internet LEDs on the front panel
light up green.
I
The Power LED will flash green
for a few seconds when the
Router goes through its self-
diagnostic test. This LED will stay
solidly lit when the self-test is
complete. If it does not stop
flashing, refer to "Appendix A:
Troubleshooting" in the Router's
User Guide on the Setup CD-
ROM.
J
Power on the PC you wish to
use to configure the Router.
Proceed to Step 2.
E
G
Make sure you use
IMPORTANT:
the power adapter that is supplied
with the Router. Use of a different
power adapter could damage the
Router.
3