SEVERIN SM9688 Mode D'emploi page 9

is operated when empty.
 Caution: Overfi lling the container may
cause danger if frothing milk is forced out.
 Caution: Th e lid must be fi tted during
operation.
 Caution: Th e milk container heats up
during operation. Do not touch hot
surfaces.
Hold the container only by its handle.
 Th e appliance may only be used with the
original accessory parts provided by the
manufacturer.
 Th e appliance must always be set on a fi rm,
level surface.
 Do not allow the appliance or its power
cord to come into contact with open
fl ames or any hot surfaces such as hot-
plates.
 Do not allow the power cord to hang free;
the cord must be kept well away from hot
parts of the appliance.
 Always remove the plug from the wall
socket
- in case of any malfunction,
- aft er use,
- before cleaning the appliance.
 When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
 No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
 Th is appliance is intended for domestic or
similar applications, such as
- in shops, offi ces and other similar
working environments,
- in agricultural areas,
- by customers in hotels, motels etc. and
similar establishments,
- in bed-and breakfast type environments.
 In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service
address can be found in the appendix to
departments. Th e
this manual.
Before using for the fi rst time
Remove any packaging materials and check
that all components are present.
Before the appliance is used for the fi rst
time, or aft er extended periods of non-use, it
should be thoroughly cleaned as described in
the section General Care and Cleaning.
Operation
We recommend the use of long-life milk
(UHT) with a high protein content. For best
results, the milk should be taken from the
refrigerator immediately before frothing.
Th e underside of the container and the contact
area on the inside of the base must be clean
and dry.
Choosing the stirring head
 Use the smooth stirring head to heat up
milk.
 For frothing and heating milk at the same
time, use the serrated head.
 For cold-frothing milk, also use the
serrated head.
 Th e head not currently in use can be
stored in the rear of the housing.
Fill amounts
 Always observe the minimum mark and
ensure the container is fi lled with at least
120 ml milk.
 For frothing, fi ll the container to a
maximum of 350 ml (lower max mark
 For heating, fi ll the container to a
maximum of 700 ml (upper max mark
).
Heating up or frothing milk
 Place the container onto the base.
 Remove the lid from the milk container.
 Place the appropriate head onto the
mounting protrusion inside the bottom of
the container.
 Put the required amount of milk into the
container.
9
).