Warn 80540 Instructions De Montage page 5

II. Kit Installation, continued
6. Remove bolts securing grab bar to frame. (figure
5)
7. Remove front grab bar from the ATV. (figure 6)
8. Mount the roller fairlead to the mounting bracket
using the M10-1.5 x 20mm hex head cap screws,
lock washers and hex nuts. (figure 7)
9. Place winch mounting bracket into position on
the winch and attach using 2 M8-1.25 x 20mm
hex head cap screws and lock washers in the
forward two mounting holes. On the motor side
of the winch in the rear mounting hole use the
M8-1.25 x 20mm countersunk cap screw. On the
clutch endhousing side of the winch use the M8-
1.25 x 16mm countersunk cap screw. (figure 8)
WARN® INDUSTRIES
Remove
PAGE 5
Remove
Figure 5
Figure 6
Figure 7
Figure 8
80539 Rev A0