AN SPX BRAND Radiodetection RD8000 Mode D'emploi page 10

Before you begin
IMPORTANT! Please read this section before you attempt to operate the RD8000!
Starting the system
The receiver and transmitter are battery powered. Install good quality D-cell NiMH or
Alkaline batteries into the receiver and transmitter battery compartments. Alternatively,
you can power the transmitter from a mains or vehicle power source using a
Radiodetection supplied adapter.
To switch the receiver or the transmitter on, press and hold the
NOTE: Once the system is switched on, pressing the
activate the receiver or transmitter menu.
Shutting down
To switch the receiver or the transmitter off, press and hold the
System setup
It is important that you set up the system according to your personal preferences and
operating requirements before you conduct your first survey. You can set the system up
using the RD8000 menu as described below.
Before changing settings, ensure the receiver or transmitter is switched on by pressing
the keypad key for two seconds.
Power / mains frequency
Select the correct frequency (50 or 60Hz) for your country or region's national power
supply. To change power frequency on the transmitter and the receiver:
1. Press the
the menu.
2. Scroll to the POWER option using the arrow keys.
3. Press the
. Scroll up or down using the
. Press the
. Press the
key momentarily to enter
key to enter the POWER submenu.
or
key to accept your selection and return to the main menu.
key to return to the main operation screen.
key momentarily will
arrows to select the correct frequency.
10
key for two seconds.
key for two seconds.