SPARKY X 52E Notice Originale page 9

of high-quality router bits in order to guarantee
sufficient operating life (E.g. HSS router bits or
even better carbide tipped bits.)
Use only router bits with exact shank diameter,
fîr to the corresponding collet and appropriate
for the router speed.
SWITCHING ON - SWITCHING Off
▪ Switching on: push the slider of ON/OFF
switch 1 forward until its front end will sag,
thus fixing itself.
▪ Switching off: press the back, lifted end of
switch 1 and release it to return in its initial
position.
WARNING: In case ambient tem-
perature is lower than 0
switched on only in "G" position of the speed
electronic regulator. After several minutes op-
eration at no-load the router can be used also
in the rest of regulator positions.
ROTATION SPEED ADjUSTMENT
Rotation speed adjustment can be varied
smoothly from A to G, through rotating the thum-
bwheel of the electronic regulator 14, placed on
the rear of the electric motor cover.
HANDLE ADjUSTMENT
Pull out the handles separately and rotate them
in position, convenient for operation , then re-
lease the handles .
REPLACING THE ROUTER BITS
Unscrew fixing screw 5 to remove the electric
motor from the supporting base, in order to
work more conveniently.
Unscrew nut III by means of the wrenches S17
and S14 and remove router bit IV from the
spindle 9.
Place the new bit in collet II and tighten nut III
completely.
Replace the electric motor in the supporting
knee cradle and tighten fixing screw 5 well
ADjUSTMENT Of CUTTING DEPTH
Lower down supporting knee until the tool will
touch the surface of the machined piece, fix it by
lever 3, and read the position on vertical ruler 13
as initial (zero) position.
Original instructions
C the router must be
o
Adjust the first depth level by guide 2, pointing to
the highest level of the three-position support 6,
reading the size on vertical ruler 13 and fix the
supporting knee with lever 3.
Fix depth guide 2 by the wing screw. (Adjust in
advance the three levels of the positioning sup-
port to the desired levels.)
- The second and the third level of cutting depth
can be achieved by only rotating the disk of the
three-position support 6 and moving the support
knee until depth guide 2 will touch the corre-
spon-ding level of the support.
Check the sizes on the vertical ruler or by a ref-
erence part (test part).
USAGE Of THE PARALLEL GUIDE
The parallel guide 10 is used for cutting edges
and grooves parallel to them at a predefined dis-
tance. Adjusting the distance is accomplished by
using horizontal ruler 7, after that parallel guide
10 being fixed with screws 11.
ROUTING AGAINST DRAWING
(DRAfT)
It is performed without parallel guide 10, against
the preliminary drawn on the workpiece draft.
Better results can be achieved if machining
smaller lengths.
ROUTING BIG WORKPIECES
In order to guide the router bit use an auxiliary
board fixed on the machined surface. Guide the
router with both hands, the flat part of the router
base 8 being constantly pressed against the
auxiliary board.
ROUTING WITH SUCTION
Place the adapter in the cradle in base 8, from
its lower side, cylindrical part pointing forward.
Fix the adapter to the base with two screws and
place the transparent cover. The inner diameter
of the adapter for connecting to the vacuum-
cleaner is equal to 35 mm.
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
▪ HSS router bits - Ø6; Ø8
▪ Carbide tipped bits - Ø6; Ø8
7
EN