VINCENT SA-T7 Manuel D'utilisation page 25

1
5
1. TREBLE
Knob for setting the treble proportions (high fre-
quencies) of the sound. The middle position keeps
the high tones unchanged.
2. POWER
This is the main power switch for turning on and
off the device. The preamplifier is separated from
the mains voltage when switched off and cannot
be set into a standby state.
3. BASS
Knob for setting the bass proportions (low fre-
quencies) of the sound. The middle position keeps
the bass unchanged.
4. TONE
If deactivated, audio signals bypass the tone con-
trol that has been set with the BASS and TREBLE
dials.
5. Display window for the tube
6. SR: sensor diode for the remote control
FRONT VIEW
2 3
6 7
3
8
7. INPUT: Input Selector
This dial allows you to choose one of the six inputs.
The LED that is actually lit shows you what input
channel has been selected. Additionally these LEDs
show that the appliance is switched on.
8. Analog/Digital
Button to choose between analog and digital
inputs. For further information see page 35.
9. VOLUME: Volume dial
This is the knob for the adjustment of the main
volume level of the system. The LED in this dial is
blinking for some seconds while after switching
on the tubes are being warmed up or while the
preamplifier is muted.
10. MUTE
Press this button to mute your system's loudspeakers
as an effect of muting the signals of the preamplifier
output "OUTPUT" (14) and the recording output
"REC OUTPUT" (12). After pressing this button
again the original volume level is being restored.
4
9
Vincent
25