YAKINIKU Shichirin Instructions page 59

om Support 1
ch the support 1 to the supprot 2 with one M6 Screw
Attach the support 1 to the supprot 2 with one M6 Screw
Attach the band to the bottom support with two M6 screws and
Acorn Nut by hand. Refer to picture of Step 1.
Step 1
al Heat Shield
Step 2
and Acorn Nut by hand. Refer to picture of Step 1.
ÉTAPE 1
acorn nuts by hand. Refer to picture of Step 2.
h the band to the bottom support with two M6 screws and
Attach the band to the bottom support with two M6 screws and
Repeat Step 2.
Step 2
nuts by hand. Refer to picture of Step 2.
Step 3 acorn nuts by hand. Refer to picture of Step 2.
ws (5x10mm) 5 x Acorn Nuts & M6 Screws
Attach the support 1 to the supprot 2 with one M6 Screw
Refer to picture of Step 3.
ÉTAPE 3
Attached the bamboo handle to the bands with 4 screws
and Acorn Nut by hand. Refer to picture of Step 1.
Step 4
by screwdriver and tightened. The handle's Logo facing up.
Refer to picture of Step 4.
Repeat Step 2.
2
eat Step 2. Attach the band to the bottom support with two M6 screws and
Step 3
Refer to picture of Step 3.
acorn nuts by hand. Refer to picture of Step 2.
r to picture of Step 3. Repeat Step 4.
Step 5
ÉTAPE 5
Refer to picture of Step 5.
Repeat Step 2.
2
Refer to picture of Step 3.
Tighten all screws by wrench. Then put the metal heat shield
Step 6
on the stand.
FR
3
1 x Bottom Support 2
1 x Bamboo Heat Shield
Attached the bamboo handle to the bands with 4 screws
Attach the band to the bottom support with two M6 screws and
Step 4
Step 2 by screwdriver and tightened. The handle's Logo facing up.
Step 4
acorn nuts by hand. Refer to picture of Step 2.
Step 5
ÉTAPE 2
Refer to picture of Step 4.
Repeat Step 2.
Repeat Step 4.
Step 3
Step 5
Step 5
Refer to picture of Step 3.
Attached the bamboo handle to the bands with 4 screws Step 6
Refer to picture of Step 5.
Step 4
ÉTAPE 4
by screwdriver and tightened. The handle's Logo facing up.
Refer to picture of Step 4.
2
3
Repeat Step 4.
Tighten all screws by wrench. Then put the metal heat shield
Step 6
Step 5
Step 6
Refer to picture of Step 5.
on the stand.
ÉTAPE 6
Tighten all screws by wrench. Then put the metal heat shield
3
Step 6
3
on the stand.
59
3
Attached the bamboo handle to the bands with 4 s
Repeat Step 4.
by screwdriver and tightened. The handle's Logo fa
Refer to picture of Step 5.
Refer to picture of Step 4.
Repeat Step 4.
Tighten all screws by wrench. Then put the metal
Refer to picture of Step 5.
on the stand.
Tighten all screws by wrench. Then put the metal
on the stand.
S
S
3